Welcome to the fluidfm forum

This community is for professionals and enthusiasts of our products and services. Share and discuss the best applications, experiments and new ideas, build your professional profile and become a better researcher together.

Please read the guidelines before participating in this community.

0

FluidFM BOT Probe preparation

By
Paul Monnier
on 11/20/18, 3:52 AM 32 views

To achieve optimal results, follow these steps during probe preparation:

  • Make sure your liquid has been filtered through maximum 0.2µm pores size

  • Use the a 1µl pipette to aspirate 0.5 to 1µl of the solution you would like to use and wipe the tip to avoid contamination outside the reservoir.

  • Insert the pipette tip until you reach the bottom of the reservoir and eject the solution there.









  • Place probe into the probeholder and pick it up as soon as possible to avoid evaporation of your solution.

     

Warning!

Be careful to keep the upper border of the reservoir clean. Any presence of liquid may be deposited on the sealing screw. This could lead to cross contamination and air tightness failure. In case of contamination, please refer to cleaning of the sealing screw.

Add a Comment

Keep Informed

About This Community

This community is for professionals and enthusiasts of our products and services. Share and discuss the best applications, experiments and new ideas, build your professional profile and become a better researcher together. Read Guidelines

Question tools

1 follower(s)

Stats

Asked: 11/20/18, 3:52 AM
Seen: 32 times
Last updated: 11/20/18, 3:54 AM